The short answer
FrostPeak AC Repair fixes gas furnaces in Los Gatos homes, including ignition, airflow, blower, and safety-switch problems. Bay Area Air District rules do not require you to replace a working furnace, so repairing a sound unit is still a reasonable choice.
Los Gatos winters are mild but damp, and nights get cold enough that most homes rely on the furnace from late fall into early spring. When a furnace fails, it is often on the first chilly evening of the season, after months of sitting idle. FrostPeak AC Repair is based in San Jose, about 5 miles northeast of Los Gatos, and we repair gas furnaces for homeowners in the 95030 and 95032 ZIP codes. This page covers what tends to go wrong, what a repair visit looks like, and how current Bay Area rules affect the choice between repairing and replacing.
Why Los Gatos furnaces act up at the start of the season
The Santa Clara Valley has a Mediterranean climate, with dry summers and mild, damp winters. A furnace in Los Gatos may sit unused for six months or more, then run every night once the weather turns. During that idle stretch, dust settles on the burners and flame sensor and filters get forgotten. Small problems that started last spring tend to show up all at once.
If your furnace is in an attic, crawlspace, or garage, it also deals with temperature swings and more dust than a unit in an indoor closet. That can wear on wiring, the blower, and venting connections. We look at the installation location and venting on every visit, not just the part that stopped working.
Common furnace problems we repair
Most no-heat and low-heat calls trace back to a short list of causes. These are the problems we see most often:
- The fan runs but blows cool air, often because of a dirty flame sensor or an ignition fault
- An igniter that glows but doesn't light the burners, or doesn't glow at all
- Short cycling, where the burners light and then shut off within a few minutes
- A blower motor that hums, squeals, or won't start
- A tripped high-limit switch caused by a clogged filter or blocked return vents
- Pressure switch or inducer fan faults, which usually show up as a blinking error code
- Thermostat wiring or settings that keep the furnace from calling for heat
- Uneven heat between rooms or between floors
What happens during a repair visit
We start by asking what you've noticed, such as noises, smells, error codes, or when the problem began. Then we test the system in order: thermostat signal, power, gas supply, ignition sequence, flame, airflow, and safety controls. We also inspect the venting and look at the heat exchanger for visible damage, since a cracked heat exchanger can let combustion gases into the home.
Before any work begins, we explain what we found and what the repair involves. If we find a safety concern, we'll tell you plainly and may recommend leaving the furnace off until it's fixed.
A few quick checks before you call can save time, and sometimes they solve the problem:
- Replace or check the air filter
- Make sure the thermostat is set to Heat and has fresh batteries if it uses them
- Confirm the furnace power switch is on and the breaker hasn't tripped
- Note any blinking light pattern on the control board
Repair or replace? What Bay Area rules mean for you
Under Bay Area Air District Rule 9-4, natural gas furnaces manufactured from 2029 must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when a furnace is replaced after that date. The rule does not require you to replace working equipment. It applies only when an existing furnace fails or is replaced, so repairing a furnace that is otherwise in good shape is still allowed.
If your furnace is older and facing a major repair, a heat pump may be worth comparing against the repair. Keep in mind that the federal 25C tax credit covered qualifying heat pumps placed in service before December 31, 2025. It is not available for new installations. Bay Area homeowners can check BayREN and their local clean energy provider for current heat pump incentives. Those programs change by funding cycle, so we confirm the current offer before including it in any quote.
Serving Los Gatos and nearby towns
We work throughout Los Gatos and the surrounding part of Santa Clara County, including Monte Sereno, Campbell, Saratoga, Cupertino, and Santa Clara. Because we're based in nearby San Jose, Los Gatos is a short drive for our technicians. When you call, have the furnace's make and model ready if you can find the label, along with a description of the problem.
More services in Los Gatos
- AC Repair in Los Gatos
- Heating Repair in Los Gatos
- Heat Pump Installation in Los Gatos
- AC Installation in Los Gatos

