Skip to content

Furnace Repair in Mountain View, CA

Serving Mountain View and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (669) 267-6986

The short answer

FrostPeak AC Repair fixes gas furnaces in Mountain View homes, including ignition failures, short cycling, blower problems, and no-heat calls. You are not required to replace a working furnace under current Bay Area Air District rules, so repair is often a reasonable choice.

Mountain View winters are mild, but nights from late fall through early spring get cold and damp enough that a furnace that won't light, keeps shutting off, or blows lukewarm air becomes a real problem fast. FrostPeak AC Repair sends technicians from our base in San Jose, about 15 miles southeast, to homes in the 94040, 94041, and 94043 ZIP codes. We find the actual fault, explain it in plain terms, and tell you whether a repair makes sense or whether it's time to talk about replacement.

Common Furnace Problems in Mountain View Homes

The Santa Clara Valley has dry summers and mild winters, so many local furnaces sit unused for months at a time. That long idle stretch is why problems tend to show up on the first cold night of the season. Dust settles on burners, flame sensors pick up residue, igniters weaken, and blower motors that haven't turned in months start to complain.

These are the symptoms we're most often called about:

  • Furnace runs but blows cool or lukewarm air
  • Burners light, then shut off after a few seconds
  • Igniter clicks or glows but the burners never light
  • Short cycling, where the furnace turns on and off repeatedly
  • A burning-dust smell that doesn't fade after the first few heating cycles
  • Banging, squealing, or rattling from the blower or ductwork
  • Thermostat calls for heat but nothing happens
  • Some rooms stay noticeably colder than others

What Happens During a Furnace Repair Visit

We start with the basics: thermostat settings, power to the unit, gas supply, and the air filter. A surprising number of no-heat calls come down to one of these. From there, we test the components that most often fail, including the igniter, flame sensor, pressure switch, limit switch, inducer motor, blower motor, and control board. If the board shows a fault code, we use it as a starting point, not a final answer.

We also look at venting and check the heat exchanger where it can be seen, because a cracked heat exchanger or blocked flue is a safety issue, not just a comfort issue. Before any work begins, we explain what we found and what the repair involves. If the needed part is on the truck, many common repairs can be finished during the same visit. If not, we'll tell you what has to be ordered.

If you ever smell gas or your carbon monoxide alarm goes off, leave the house first and contact your gas utility's emergency line or emergency services from outside. Don't try to diagnose it yourself.

Repair or Replace? What the Bay Area Rules Mean for You

Under Bay Area Air District Rule 9-4, natural gas furnaces manufactured from 2029 onward must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when they replace a furnace after that date. The rule does not require you to replace working equipment. It only applies when an existing furnace fails or is replaced. If your furnace has a fixable problem, repairing it is still a legitimate option.

Where the rules matter is planning. If your furnace is older and facing a costly repair, it's worth weighing that repair against a heat pump now, rather than waiting for a failure in the middle of winter. Bay Area homeowners can check BayREN and their local clean energy provider for current heat pump and electrification incentives. Those programs change by funding cycle, so we confirm what's currently available before including it in any quote. Note that the federal Energy Efficient Home Improvement Credit (25C) only covered qualifying heat pumps placed in service before December 31, 2025, and it isn't available for new installations.

Quick Checks Before You Schedule

A few safe checks can sometimes get your heat back or help us diagnose faster:

  • Confirm the thermostat is set to Heat and the setpoint is above room temperature
  • Replace thermostat batteries if the display is dim or blank
  • Swap out a dirty air filter
  • Check that the furnace breaker and the service switch near the unit are on
  • Make sure the furnace's front panel is fully seated, since a loose panel can trip a safety switch
  • Note any blinking light pattern on the control board and tell us when you call

Serving Mountain View and Nearby Cities

We handle furnace repair throughout Mountain View, from homes closer to the Bay to neighborhoods toward the foothills. We also serve nearby Los Altos, Sunnyvale, Cupertino, Santa Clara, and Saratoga, so if you own property in more than one of these cities, the same team can look after both.

More services in Mountain View

Related

What to expect

How a visit goes

  1. Find the cause first

    We test the system and pinpoint what's wrong before suggesting parts or replacement, so you aren't paying to guess.

  2. Explain it in plain language

    You'll hear what failed, why it likely happened, and what each option involves, without jargon or pressure.

  3. Give you real choices

    When repair and replacement are both reasonable, we lay out the tradeoffs and let you choose what fits your home and plans.

FAQ

Common questions

Why does my furnace smell like burning when I first turn it on?

Dust settles on the burners and heat exchanger over the warm months, and it burns off when the furnace first runs. That smell should fade within a few cycles. If it persists, smells electrical, or you notice smoke, turn the furnace off and have it checked.

Do I have to replace my gas furnace because of the Air District rules?

No. The Bay Area Air District appliance rules don't require replacing working equipment. They apply only when an existing furnace fails or is replaced, and the zero-NOx standard covers furnaces manufactured from 2029.

Is it worth repairing an older furnace?

Often it is, especially for parts like igniters, flame sensors, and pressure switches. If the repair is major, such as a heat exchanger or control board on an aging unit, we'll walk you through repair versus a heat pump so you can decide with the full picture.

Can I still get a federal tax credit for a heat pump?

The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025, and isn't available for new installations. Check BayREN and your local clean energy provider for current incentives. We confirm current offers before quoting them.

How can I tell if the problem is my thermostat or my furnace?

If the thermostat display is blank, has the wrong mode set, or doesn't click when you raise the temperature, start there. If the thermostat is calling for heat and the furnace still won't start or stay lit, the problem is likely in the furnace itself.

Which parts of Mountain View do you serve?

We serve homes across Mountain View, including the 94040, 94041, and 94043 ZIP codes, as well as nearby Los Altos, Sunnyvale, Cupertino, Santa Clara, and Saratoga.

Tell us what your system is doing

Whether your AC is blowing warm air, your furnace won't start, or you're weighing a heat pump, contact FrostPeak AC Repair. We'll start with a diagnosis and walk you through your options.

Call (669) 267-6986 Request Service