Skip to content

Heating Repair in Saratoga, CA

Serving Saratoga and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (669) 267-6986

The short answer

FrostPeak AC Repair repairs gas furnaces, heat pumps, thermostats and duct problems in Saratoga homes. We find the cause, explain your options, and fix what is worth fixing. If a furnace needs replacing, we explain how the Bay Area Air District rules may affect that choice.

Saratoga winters are mild by most standards, but the damp, chilly evenings from late fall through early spring are when a heating problem gets noticed. Maybe the furnace runs but blows cool air, the heat pump stays on without warming the house, or one end of the home never reaches the thermostat setting. FrostPeak AC Repair comes over from our base in San Jose, about 9 miles east, to diagnose and repair gas furnaces, heat pumps and the controls and ductwork connected to them in homes throughout the 95070 ZIP code. Our goal is to find the actual cause, explain it plainly, and fix it.

Heating Problems We See in Saratoga Homes

Saratoga has many kinds of homes, from older single-story houses to larger homes with more than one system or zone. Many heating systems here run only part of the year, so problems often show up on the first cold night after months of sitting idle. Dust on burners, a weak igniter or a thermostat with dying batteries can all stay hidden until the heat is needed.

These are the problems we diagnose and repair most often:

  • Furnace that clicks or tries to light but never fully ignites
  • Burners that light, then shut off after a few seconds, often from a dirty flame sensor
  • Blower running but only cool or lukewarm air coming from the vents
  • Heat pump that runs constantly in heat mode without warming the house, or ices up and doesn't defrost
  • Short cycling, where the system turns on and off every few minutes
  • Rooms far from the equipment staying cold because of leaking or disconnected ducts in the attic or crawlspace
  • Thermostat or zone control problems on homes with more than one system
  • New rattling, squealing or booming sounds at startup

Quick Checks Before You Call

Some no-heat calls have simple causes. Before scheduling a visit, it's worth checking a few things yourself. If you smell gas or suspect a carbon monoxide problem, leave the house and call your gas utility or 911 instead.

  • Confirm the thermostat is set to Heat and set a few degrees above room temperature
  • Replace thermostat batteries if the display is blank or faint
  • Check the breaker and the service switch near the furnace or air handler
  • Look at the air filter; a badly clogged filter can make the system overheat and shut itself off
  • Make sure the furnace panel door is fully closed, since a safety switch can keep it from running

How a Heating Repair Visit Works

We start with what you've noticed: when the problem started, what the system does, and whether it has happened before. Then we test the equipment while it runs, including the ignition sequence, flame, safety switches, blower, airflow and thermostat signal. On heat pumps we also check refrigerant-side operation and defrost controls, because a heat pump that seems to be failing is sometimes just low on charge or stuck in a defrost problem.

Before any work starts, we explain what we found and what the repair involves. If a part has to be ordered, we tell you so and keep the system running safely in the meantime when we can. When we find a safety issue on a gas furnace, such as signs of a cracked heat exchanger or poor venting, we explain it clearly and don't leave it running in an unsafe condition.

Repair or Replace: What Bay Area Rules Mean for You

Most heating problems can be repaired, and we'll tell you when a repair makes sense. When an older furnace keeps failing, some homeowners start thinking about replacement, and local rules are worth knowing about. Under the Bay Area Air District's Rule 9-4, natural gas furnaces made starting in 2029 must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when they replace a furnace after that date.

These rules do not require you to remove working equipment. They apply only when a furnace or water heater fails or is replaced, so repairing a furnace that still works is an option. If you're also planning a water heater replacement, check the current version of Rule 9-6 first. Its 2027 zero-NOx date for small water heaters may be amended. The federal 25C tax credit for heat pumps ended for systems placed in service after December 31, 2025. However, BayREN and your local clean energy provider may still offer incentives. Amounts and availability change between funding cycles, so we confirm the current offer before including it in a quote.

Serving Saratoga and Nearby Communities

We work throughout Saratoga and the 95070 ZIP code, along with nearby Santa Clara County communities including Monte Sereno, Los Gatos, Cupertino, Campbell and Santa Clara. Saratoga sits on the west side of the Santa Clara Valley, which has dry summers and mild, damp winters. Heating systems here run less often than in colder regions, so small problems can go unnoticed until a cold snap. When that happens, we're nearby and ready to help.

More services in Saratoga

Related

What to expect

How a visit goes

  1. Find the cause first

    We test the system and pinpoint what's wrong before suggesting parts or replacement, so you aren't paying to guess.

  2. Explain it in plain language

    You'll hear what failed, why it likely happened, and what each option involves, without jargon or pressure.

  3. Give you real choices

    When repair and replacement are both reasonable, we lay out the tradeoffs and let you choose what fits your home and plans.

FAQ

Common questions

Why does my furnace turn on and then shut off after a few seconds?

A common cause is a dirty or failing flame sensor. The furnace can't confirm a flame, so it shuts the gas off for safety. Overheating from a clogged filter or a venting problem can cause similar behavior. We test each possibility before replacing anything.

Is it normal for my heat pump to blow air that feels lukewarm?

Heat pump air often feels cooler than air from a gas furnace, even when the system is working correctly. If the house isn't reaching the thermostat setting, the system runs nonstop, or the outdoor unit stays iced over, it needs a closer look.

Do I have to replace my gas furnace because of the new Air District rules?

No. The Bay Area Air District rules don't require replacing working equipment. They apply when an existing furnace fails or is replaced, and the zero-NOx standard covers gas furnaces manufactured starting in 2029.

Can I still get the federal tax credit for a heat pump?

The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025, so new installations don't qualify. BayREN and local clean energy providers may have current incentives, and we confirm what is available before quoting it.

Why is one part of my house always colder than the rest?

Uneven heat is often caused by duct problems, such as leaking, crushed or disconnected runs in the attic or crawlspace. It can also come from closed or blocked vents or a zoning control that isn't working. We check airflow at the registers and inspect the accessible ductwork.

What should I do if I smell gas near my furnace?

Leave the house right away and call your gas utility or 911 from outside. Don't use light switches or try to restart the furnace. Once the utility has made the area safe, we can diagnose and repair the furnace.

Tell us what your system is doing

Whether your AC is blowing warm air, your furnace won't start, or you're weighing a heat pump, contact FrostPeak AC Repair. We'll start with a diagnosis and walk you through your options.

Call (669) 267-6986 Request Service