Skip to content

Furnace Repair in Cupertino, CA

Serving Cupertino and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (669) 267-6986

The short answer

FrostPeak AC Repair repairs gas furnaces in Cupertino homes, from failed igniters and flame sensors to blower motors, thermostats, and safety switch faults. We diagnose the actual cause first, explain your repair and replacement options, and you don't have to replace a working furnace because of the Bay Area's newer appliance rules.

Cupertino winters are mild and damp rather than harsh, so most home furnaces sit idle through the long dry summer and then run mainly on cool mornings and evenings from late fall into spring. That on-and-off pattern causes its own problems: dust burning off the heat exchanger, an igniter that gives out after months of rest, a flame sensor coated with residue, or a filter nobody has changed since last winter. FrostPeak AC Repair sends technicians from our base in San Jose, about 10 miles east, to homes throughout Cupertino's 95014 ZIP code to find out why a furnace isn't heating and fix it.

Furnace Problems We See Most in Cupertino Homes

Because furnaces in the Santa Clara Valley often go months without running, many service calls come in the first cold week of the season. The furnace either won't start at all or starts, runs briefly, and shuts down. Most of these problems trace back to a few parts.

  • Hot surface igniters that crack or wear out and no longer light the burners
  • Dirty flame sensors that make the furnace shut off a few seconds after lighting
  • Clogged filters that cause overheating and trip the high-limit switch
  • Pressure switch and inducer motor faults that stop the ignition sequence
  • Blower motors or capacitors that fail, so the burners run but little air reaches the rooms
  • Thermostats with dead batteries, bad wiring, or incorrect settings after a summer of cooling

What Happens During a Repair Visit

Your technician starts by asking what you've noticed: odd noises, short cycling, a burning smell, cold air from the vents, or a furnace that won't respond at all. Many newer furnaces flash a fault code on a control board light, and that code points to where to look first.

From there we check the thermostat signal, the ignition sequence, gas supply to the unit, airflow, and the safety switches that protect your home. We explain what failed and why, and we tell you about your options before any work begins. If a part has to be ordered, we'll let you know and help you stay as comfortable as possible in the meantime.

Repair or Replace? What Bay Area Rules Mean for Your Furnace

Under Bay Area Air District Rule 9-4, natural gas furnaces manufactured from 2029 onward must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when a furnace is replaced after that date. These rules don't require you to replace working equipment. They apply only when an existing furnace fails or is replaced, so repairing the furnace you have is still a reasonable choice.

If your furnace is older and needs frequent repairs, it can make sense to start thinking about a heat pump now instead of during an emergency. Keep in mind that the federal 25C tax credit for heat pumps applied only to systems placed in service before December 31, 2025, and isn't available for new installations. Bay Area homeowners can still check BayREN and their local clean energy provider for current heat pump and electrification incentives. Those amounts change with each funding cycle, so we confirm the current offer before including it in any quote.

When to Turn the Furnace Off and Get Help

Some symptoms are more than an inconvenience. If you smell gas, leave the house and contact your gas utility from outside. If a carbon monoxide alarm sounds, get everyone outdoors. Turn the furnace off and call for service if you notice any of the following:

  • A burning or electrical smell that continues after the first few minutes of the season
  • Scorch marks or soot around the burner area
  • Loud banging when the burners light
  • A breaker that trips each time the furnace runs

Quick Checks Before You Call

A few simple checks can save you a visit. Make sure the thermostat is set to heat and the setpoint is above room temperature. Replace the thermostat batteries if it uses them. Confirm the furnace's power switch, which often looks like a light switch near the unit, is on, and that the furnace panel door is fully closed, since many units won't run with it loose. Check the filter and replace it if it's dirty.

If the furnace still won't heat, we can help. Along with Cupertino, we serve nearby Saratoga, Los Altos, Sunnyvale, Santa Clara, and Campbell.

More services in Cupertino

Related

What to expect

How a visit goes

  1. Find the cause first

    We test the system and pinpoint what's wrong before suggesting parts or replacement, so you aren't paying to guess.

  2. Explain it in plain language

    You'll hear what failed, why it likely happened, and what each option involves, without jargon or pressure.

  3. Give you real choices

    When repair and replacement are both reasonable, we lay out the tradeoffs and let you choose what fits your home and plans.

FAQ

Common questions

Why does my furnace smell like burning when I first turn it on?

Dust settles on the burners and heat exchanger during the months the furnace sits unused. A light dusty smell for the first few minutes is normal. If the smell is electrical, gets stronger, or doesn't go away, turn the furnace off and schedule a repair.

My furnace lights and then shuts off after a few seconds. What causes that?

This is often a dirty or failing flame sensor, which can't confirm the flame and shuts off the gas for safety. Other causes include airflow problems and pressure switch faults. A technician can test each one to find the actual cause.

Do I have to replace my gas furnace because of the new Air District rules?

No. The Bay Area Air District appliance rules don't require replacing working equipment. They apply only when a furnace fails or is replaced, and the zero-NOx standard covers gas furnaces manufactured from 2029 onward.

Can I still get a federal tax credit for a heat pump?

The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025, and isn't available for new installations. You can check BayREN and your local clean energy provider for current incentives, and we confirm what's available before quoting it.

How often should I change my furnace filter?

Check it at the start of the heating season and every month or two while the furnace runs. Homes with pets, nearby construction, or wildfire smoke may need more frequent changes. A clogged filter is one of the most common reasons a furnace overheats and shuts down.

Do you repair furnaces outside Cupertino?

Yes. We're based in San Jose and also serve Saratoga, Los Altos, Sunnyvale, Santa Clara, and Campbell.

Tell us what your system is doing

Whether your AC is blowing warm air, your furnace won't start, or you're weighing a heat pump, contact FrostPeak AC Repair. We'll start with a diagnosis and walk you through your options.

Call (669) 267-6986 Request Service